Table of Contents
Advertisement
4. Press the Plus or Minus button to adjust
the cycle time for F2.
5. Wait 15 seconds to allow the exit timer to
expire and store the setting.
IMPORTANT: To reset the first filter cycle start
time, skip step 5 and continue pressing the
Program Mode button until the actual temperature
is displayed. Powering down of the spa will also
reset the first filter start time.
FILTER CYCLE SUSPENSION:
filter cycle will be suspended every time a jet pump
or light is activated manually during the filter cycle
time. The suspension will end 10 minutes after the
completion of the manual use.
OPERATIONAL MODES
The Standard Mode is the default operational
mode preset from the factory. In order to program
the spa to operate in the Economy mode you must
enter the programming mode to make the change.
NOTE: Freeze Protection (Smart Winter Mode) will
assert as necessary during all modes.
STANDARD MODE:
to maintain the desired temperature with periodic
water circulation (sampling) to sample and heat
the water to the set temperature.
ECONOMY MODE:
and heating of the water will be done normally
during the filter cycles, outside of these periods
the water temperature will be regulated 20°F
(11°C) below selected set temperature.
SLEEP MODE:
(SL) Water sampling and
heating is only done during the filter cycles
while trying to bring the spa water up to the set
temperature.
QUIET MODE:
(NT) Maintains temperature
with periodic sampling between the start of F1
and the end of F2 while not allowing any water
sampling to happen between the end of F2 and
the start
of F1.
CONTROL PANEL OPERATION
The
(St) Is programmed
(Ec) Water sampling
For further inquiries, please contact our Customer Service Team
Email: ahsservice@watkinsmfg.com
To enter the programming screen and toggle
between Standard, Economy, Sleep and Quiet
Modes the following is required:
1. Press and hold the Program Mode button
for 5 seconds.
2. Press the Program Mode button several
times until St, Ec, SL, or nt is displayed.
3. Use the Plus or Minus button to choose
between the Modes.
ST = Standard Mode, Ec = Economy
Mode, SL = Sleep Mode and NT = Quiet
Mode.
4. Wait 15 seconds to allow the exit timer to
expire and store the setting.
OFF MODE:
This mode allows you to stop all
spa functions for 30 minutes to perform quick spa
maintenance. To place the spa in OFF MODE,
press and hold the Jets button for 5 seconds.
The display will toggle between OFF and water
temperature when in the OFF MODE. To stop the
OFF MODE before the 30 minute cycle time is
complete, simply tap (short press) the Jet button.
FAHRENHEIT/CELSIUS SETTING
To change water temperature display to either
Fahrenheit or Celsius, press and hold Mode button
for 5 seconds until F1... is displayed. Press the
Program Mode button several times until F or C
is displayed. Press the Plus or Minus button to
change. Wait 15 seconds to allow the exit timer to
expire and store the setting.
SMART WINTER MODE
The Smart Winter Mode (SWM) is used to prevent
water from freezing in the plumbing of the spa.
As soon as there is a risk of freezing, THIS
PROTECTION AUTOMATICALLY KICKS IN.
The SWM protection will turn back off only after
24 hours without a risk of freezing. During this 24
hour period, the Smart Winter Mode icon remains
on; the icon blinks when the purge is active.
Phone: 888-961-7727
12
Advertisement
Table of Contents
