Barcode Settings; Codabar; Enable/Disable Codabar; Transmit Start/Stop Characters - Inateck BS02004 Instruction Manual

Barcode Settings

Codabar

Enable/Disable Codabar

(*) Enable Codabar

Transmit START/STOP Characters

(*) Enable Codabar START/STOP
Characters

Code 11

Enable/Disable Code 11

Enable Code 11

Checksum Code

Data in a Code 11 barcode may not include the checksum code. If there is, the
checksum code is the last one or two digit(s) of the data output. The checksum
code is the value added from all data collected, to check if the data is correct.
After you set the "Code 11 without Checksum" function, the scanner can recognize
all Code 11 barcodes normally. The scanner defaults the "Code 11 without
Checksum" setting.
Enter Setup
Disable Codabar
Disable Codabar START/STOP
Characters
(*) Disable Code 11
Exit and Save
13