2 electrolux Electrolux. Thinking of you. Share more of our thinking at www.electrolux.com CONTENTS Safety information Care and cleaning Control panel What to do if… First use Technical data Daily use Installation Helpful hints and tips Environmental concerns Subject to change without notice...
Page 3
3 Warning! Any electrical component ter will collect in the bottom of the appli- (power cord, plug, compressor) must be ance. replaced by a certified service agent or Installation qualified service personnel. Important! For electrical connection 1. Power cord must not be lengthened.
4 electrolux Environment Protection shall be disposed according to the ap- plicable regulations to obtain from your This appliance does not contain gasses local authorities. Avoid damaging the which could damage the ozone layer, in cooling unit, especially at the rear near either its refrigerant circuit or insulation the heat exchanger.
5 Important! At start up the displayed tem- Eco Mode Function perature don’t correspond with the set tem- The Eco Mode function is activated by press- perature until stabilized (within 24 hours). ing key D (several times if necessary) until the...
6 electrolux es. Confirm cancellation by pressing button • flashing icon (E). • acoustic buzzer The Quick Chill bottle holder can be removed When normal conditions are restored (door if not used. closed), the alarm will stop. During the alarm phase, the buzzer can be Door open alarm switched off by pressing button (E).
7 vate the function at any time by changing the All parts inside the drawer can be removed selected temperature in the compartment. for cleaning purposes. Bottle rack Warning! The fridge compartment must be empty with Holiday function on.
8 electrolux HELPFUL HINTS AND TIPS Hints for energy saving Milk bottles: these should have a cap and should be stored in the bottle rack on the • Do not open the door frequently or leave it door. open longer than absolutely necessary.
9 uring shall be performed under steady-sta- ted conditions (without changing the load). CARE AND CLEANING Caution! Unplug the appliance before Many proprietary kitchen surface cleaners carrying out any maintenance operation. contain chemicals that can attack/damage the plastics used in this appliance. For this...
10 electrolux Periods of non-operation When the appliance is not in use for long pe- riods, take the following precautions: 1. disconnect the appliance from electricity supply 2. remove all food 3. defrost and clean the appliance and all accessories 4.
Page 11
11 Problem Possible cause Solution The appliance is noisy. The appliance is not supported Check if the appliance stands sta- properly. ble (all feet and wheels should be on the floor). Refer to "Levelling". The spacers located between the Put them back in place again.
12 electrolux Problem Possible cause Solution Large quantities of food to be Insert smaller quantities of food to cooled were put in at the same be cooled at the same time. time. The appliance does not The appliance is switched off.
13 TECHNICAL DATA ERE38403W ERE38407W ERE38403X ERE38407X Dimension Height 1800 mm 1800 mm Width 595 mm 595 mm Depth 623 mm 623 mm The technical information are situated in the rating plate on the internal left side of the ap- pliance and in the energy label.
Page 14
14 electrolux Removing the transport support Your appliance is equipped with transport support to secure the door during transpor- tation. To remove them do these steps: 1. Open the door. 2. Remove the transport support from the door sides. 3. Remove the transport support from the lower hinge (some models).
15 Levelling When placing the appliance ensure that it stands level. If necessary adjust the feet us- ing the adjustment spanner supplied. Installation of the Taste Guard filter The Taste Guard filter is an active carbon filter which absorbs bad odours maintain the best 4.
Page 16
16 electrolux 11. Remove the door closing device on the door (h1). Screw on the door closing de- vice provided within the accessory bag on the opposite side (h2). 7. Remove the cover on the front (d). 8. Unscrew and move the door stopper (e) to the opposite side.
17 17. Put the cabinet in position. Warning! Reposition, level the appliance, wait for at least four hours and then connect it to the power socket. Do a final check to make sure that: • All screws are tightened.