List Of Xclarity Controller Events - Lenovo SR850 Reference

Table 2. Events organized by severity (continued)
Message String
Event ID
FQXSPUP4000I Please ensure that the Management Controller [arg1] is flashed with
the correct firmware. The Management Controller is unable to match
its firmware to the server.
FQXSPUP4003I [arg1] firmware mismatch internal to system [arg2]. Please attempt to
flash the [arg3] firmware.
FQXSPUP4004I XCC firmware mismatch between nodes/servers [arg1] and [arg2].
Please attempt to flash the XCC firmware to the same level on all
nodes/servers.
FQXSPUP4005I FPGA firmware mismatch between nodes/servers [arg1] and [arg2].
Please attempt to flash the FPGA firmware to the same level on all
nodes/servers.
FQXSPUP4009I Please ensure that the system is flashed with the correct [arg1]
firmware. The Management Controller is unable to match the firmware
to the server.

List of XClarity Controller events

This section lists all messages that can be sent from the XClarity Controller.
• FQXSPBR4000I: Management Controller [arg1]: Configuration restored from a file by user [arg2]
from [arg3] at IP address [arg4].
This message is for the use case where a user restores a Management Controller configuration from a file.
Severity: Info
Serviceable: No
Automatically notify Support: No
Alert Category: System - Other
SNMP Trap ID: 22
CIM Prefix: IMM CIM ID: 0027
User Action:
Information only; no action is required
• FQXSPBR4001I: Running the backup Management Controller [arg1] main application.
This message is for the use case where a Management Controller has resorted to running the backup
main application.
Severity: Warning
Serviceable: No
Automatically notify Support: No
Alert Category: System - Other
SNMP Trap ID: 22
CIM Prefix: IMM CIM ID: 0030
User Action:
Update the XCC firmware. Important: Some cluster solutions require specific code levels or coordinated
code updates. If the device is part of a cluster solution, verify that the latest level of code is supported for
the cluster solution before you update the code.
• FQXSPBR4002I: Management Controller [arg1] Reset was caused by restoring default values.
24
ThinkSystem SR850 Messages and Codes Reference
Severity
Error
Error
Error
Error
Error