Lenovo SR850 Reference page 25

Table 2. Events organized by severity (continued)
Message String
Event ID
FQXSPUP2005I The firmware or software on system [ComputerSystemElementName]
are compatible.
FQXSPUP4001I Flash of [arg1] from [arg2] succeeded for user [arg3] .
FQXSPUP4002I Flash of [arg1] from [arg2] failed for user [arg3].
FQXSPUP4006I Auto promote primary XCC to backup is [arg1] by user [arg2] from
[arg3] at IP address [arg4].
FQXSPUP4007I Violation access to XCC SPI flash is detected and isolated.
FQXSPUP4008I Violation access to UEFI SPI flash is detected and isolated.
FQXSPUP4010I Flash [arg1] of [arg2] from [arg3] succeeded for user [arg4] .
FQXSPUP4011I Flash [arg1] of [arg2] from [arg3] failed for user [arg4].
FQXSPWD0000I Watchdog Timer expired for [WatchdogElementName].
FQXSPWD0001I Reboot of system [ComputerSystemElementName] initiated by
watchdog [WatchdogElementName].
FQXSPWD0002I Powering off system [ComputerSystemElementName] initiated by
watchdog [WatchdogElementName].
FQXSPWD0003I Power cycle of system [ComputerSystemElementName] initiated by
watchdog [WatchdogElementName].
FQXSPWD0004I Watchdog Timer interrupt occurred for [WatchdogElementName].
FQXSPBR4001I Running the backup Management Controller [arg1] main application.
FQXSPCA0007J Numeric sensor [NumericSensorElementName] going high (upper
non-critical) has asserted.
FQXSPCA0015J Sensor [SensorElementName] has transitioned from normal to non-
critical state.
FQXSPDM4002I Device [arg1] VPD is not valid.
FQXSPEA0003J Link down is detected on port [arg1] of the PCIe device [arg2].
FQXSPEM4040I Dust filter measurement is completed. The airflow pathway is
obstructed, check and replace the dust filter, or remove any
obstructing object.
FQXSPEM4043I A [arg1] failure has been detected and need [arg2] to recover.
FQXSPIO2000J The connector [PhysicalConnectorElementName] has been
disconnected.
FQXSPIO4001I GPU Board Status was changed by [arg1] of [arg1].
FQXSPMA0010J [PhysicalMemoryElementName] on Subsystem
[MemoryElementName] Throttled.
FQXSPMA4034G Health of DIMM [arg1] is in warning state and sub-state is [arg2].
FQXSPNM4010I DHCP[[arg1]] failure, no IP address assigned.
FQXSPNM4032I DHCPv6 failure, no IP address assigned.
The measured power value exceeded the power cap value.
FQXSPPP4009I
Severity
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Warning
Warning
Warning
Warning
Warning
Warning
Warning
Warning
Warning
Warning
Warning
Warning
Warning
Warning
.
Chapter 2 XClarity Controller events
21