Lenovo SR850 Reference page 31

1. Turn off the server and disconnect it from the power source. You must disconnect the server from AC
power cycle to reset the XCC.
2. After 45 seconds, reconnect the server to the power source and turn on the server.
3. Retry the operation.
• FQXSPBR4009I: Management Controller [arg1]: cloning configuration from neighbor server [arg2]
by group name [arg3].
This message is for the use case where a user synchronizes a Management Controller configuration by
Federation.
Severity: Info
Serviceable: No
Automatically notify Support: No
Alert Category: System - Other
SNMP Trap ID: 22
CIM Prefix: IMM CIM ID: 0255
User Action:
Information only; no action is required
• FQXSPBR400AI: Management Controller [arg1]: cloning configuration from neighbor server [arg2]
by group name [arg3] completed.
This message is for the use case where a user synchronizes a Management Controller configuration by
Federation and it completes.
Severity: Info
Serviceable: No
Automatically notify Support: No
Alert Category: System - Other
SNMP Trap ID: 22
CIM Prefix: IMM CIM ID: 0256
User Action:
Information only; no action is required
• FQXSPBR400BI: Management Controller [arg1]: cloning configuration from neighbor server [arg2]
by group name [arg3] failed to complete.
This message is for the use case where a user synchronizes a Management Controller configuration by
Federation and the restoration fails to complete.
Severity: Info
Serviceable: No
Automatically notify Support: No
Alert Category: System - Other
SNMP Trap ID: 22
CIM Prefix: IMM CIM ID: 0257
User Action:
Information only; no action is required
• FQXSPBR400CI: Management Controller [arg1]: cloning configuration from neighbor server [arg2]
by group name [arg3] failed to start.
This message is for the use case where a user synchronizes a Management Controller configuration by
Federation and the restoration fails to start.
.
Chapter 2 XClarity Controller events
27