DeLonghi ETAM29.666.S Instructions For Use Manual page 23

GROUND TOO FINE ADJUST
MILL
DESCALE
REDUCE COFFEE AMOUNT
FILL BEANS CONTAINER
INSERT INFUSER ASSEMBLY
GENERAL ALARM
EMPTY CIRCUIT FILL CIRCUIT
HOT WATER
Press OK
REPLACE FILTER
SET DIAL TO CLEAN
INSERT WATER SPOUT
INSERT MILK CONTAINER
The grinding is too fine and the coffee is delive-
red too slowly or not at all.
If the water softener filter is present, an air
bubble may have been released inside the cir-
cuit, obstructing delivery.
The machine must be descaled.
Too much coffee has been used.
The coffee beans have run out.
The pre-ground coffee funnel (A4) is clogged.
The infuser has not been replaced after clea-
ning (A17).
The inside of the appliance is very dirty.
The water circuit is empty
The water softener filter is exhausted.
Milk has been delivered recently and the tubes
inside the milk container must be cleaned.
The water spout is not inserted or is inserted
incorrectly.
The milk container is not inserted correctly.
Repeat coffee delivery and turn the grinding
adjustment dial (fig. 13) one click clockwise to-
wards "7" while the coffee mill is in operation.
If after making at least 2 coffees delivery is
still too slow, repeat the correction procedure,
turning the grinding adjustment dial another
click until delivery is correct (see the section:
"Adjusting the coffee mill on page 13). If the
problem persists, make sure the water tank is
fully inserted.
Insert the hot water spout (C3) in the appliance
and deliver a little water until the flow beco-
mes regular.
The descaling procedure described in the section
"Descaling" needs to be performed as soon as
possible (page 18).
Select a milder taste by pressing the
(fig. 11) or reduce the quantity of pre-ground
coffee.
Fill the beans container (fig. 12).
Empty the funnel with the help of a brush as
described in the section "Cleaning the pre-
ground coffee funnel" (page 17).
Insert the infuser as described in the para-
graph "Cleaning the infuser" (page 17).
Clean the inside of the appliance thoroughly,
as described in the section "Cleaning" (page
16). If the message is still displayed after
cleaning, contact a service centre.
Press
(C3) until it flows out normally. If the problem
persists, make sure the water tank is fully
inserted.
Replace the filter or remove it as described in
the section "Water softener filter" (page 20).
Turn the froth adjustment dial to CLEAN (fig. 23).
Insert the water spout (C3) as far as it will go.
Insert the milk container as far as it will go.
22
(B1) to deliver water from the spout
icon