Bean to cup espresso and cappuccino machine (20 pages)
Summary of Contents for DeLonghi ESAM5400
Page 1
BEAN TO CUP ESPRESSO AND CAPPUCCINO MACHINE Instructions for use ESAM5400...
Page 2
ElECTRICAl REqUIREMENTS (UK ONlY) Before using this appliance ensure that the voltage indicated on the product corresponds with the main voltage in your home, if you are in any doubt about your supply contact your local electricity company. The flexible mains lead is supplied connected to a B.S. 1363 fused plug having a fuse of 13 amp capacity. Should this plug not fit the socket outlets in your home, it should be cut off and replaced with a suitable plug, following the procedure outlined below.
CONTENTS HEATING WATER ......14 Preparation ............14 INTRODUCTION .........7 Changing the quantity ........15 Symbols used in these instructions ....7 ClEANING ........15 letters in brackets ...........7 Cleaning the coffee maker ......15 Troubleshooting and repairs ......7 Cleaning the coffee grounds container ...15 SAFETY ...........7 Cleaning the drip tray ........15 Fundamental safety warnings ......7...
INTRODUCTION SAFETY Thank you for choosing the eSaM5400 automa- Fundamental safety warnings tic coffee and cappuccino maker. We hope you enjoy using your new appliance. Danger! Take a few minutes to read these instructions. This is an electrical appliance and may therefore This will avoid all risks and damage to the ma- cause electric shock.
DESIGNATED USE DESCRIPTION This appliance is designed and made to prepare Description of the appliance coffee and heat drinks. all other use is conside- (page 3 red improper. grinding adjustment knob This appliance is not suitable for commercial Beans container lid use.
“ESC” button to exit from the selected • Water penetrating the coffee maker could function and go back to the main menu). cause damage. do not place the appliance P button: to access the Programming near taps or sinks. menu. • The appliance could be damaged if the water B10.
during rinsing, a little hot water flows from the 5. Press the button (fig. 4). after a few coffee spouts. avoid contact with splashes of seconds, the appliance delivers hot water and water. light comes on. To turn the appliance off, press the button The appliance ends the first start up procedure (fig.
2 or 3 hours. how many coffees have been made; Press the P button to enter the menu; how many times the machine has been Turn the selection knob until the light co- descaled; mes on; the total number of litres of water deli- Press the button to select the fun- vered;...
MAKING COFFEE The quantity of coffee in the cup has now been programmed. Selecting the coffee taste Adjusting the coffee mill The appliance is set by default to make coffee The coffee mill is preset in the factory to make with a standard taste.
lights may be displayed on the control panel du- Please note: ring use. Their meaning is given in the section The manual rinse, can be interrupted by pressing “explanation of the lights” on page 19. button. Making coffee using pre-ground coffee For hotter coffee, you should also: Important! • activate the warmer cup shelf and put the...
To avoid residual water being mixed with the milk 10. add the frothed milk to the cup of coffee pre- during frothing, you should deliver the water pared previously. first. To do this, allow the water mixed with the The cappuccino is ready. Sweeten to taste steam to flow for a few seconds until only steam and, if desired, sprinkle the froth with a little comes out.
of the spout. delivery stops automatically af- crustations or coffee deposits as they could ter 250ml. scratch metal or plastic surfaces. To interrupt delivery of hot water manually, Cleaning the coffee grounds container press the button again. When the light flashes, the coffee grounds Please note! container needs emptying.
be turned off (see “Turning off”) and unplugged rinSe WiTh WaTer only from the mains power supply. no WaShing uP liQuid - no diSh WaSher never immerse the coffee maker in water. do not use washing up liquid to clean the infuser as it could cause damage.
hamic or acetic based descalers. Their use in- Before switching on the appliance, by pressing validates the guarantee. Failure to descale the button, empty the drip tray. appliance as described above also invalidates the guarantee. SETTING WATER HARDNESS light comes on after a period of time Turn the machine on.
DISPOSAl The machine is now reprogrammed with the new water hardness setting. important information for correct disposal of the product in accordance with eC directive TECHNICAl SPECIFICATION 2002/96/eC. voltage: 220-240 v~ 50/60 hz max. 10a at the end of its working life, the product must absorbed power: 1450W not be disposed of as urban waste.
EXPlANATION OF lIGHTS lIGHT POSSIBlE CAUSE REMEDY insufficient water in the tank. Fill the tank with water and insert it correctly, pushing it as far as it will go until it clicks into place. The grinding is too fine and the coffee is deli- repeat coffee delivery and turn the grinding vered too slowly adjustment knob (fig.
TROUBlESHOOTING Below is a list of some of the possible problems. if the problem cannot be resolved as described, contact a Customer Service. PROBlEM POSSIBlE CAUSE SOlUTION The coffee is not hot The cups were not preheated. enable the cup warmer, leave the cups at least 20 minutes to warm up.