Chapter 2: Removing And Installing Components; Recommended Tools; Screw List - Dell W29C Service Manual
Hide thumbs
Also See for W29C:
- Owner's manual (119 pages) ,
- Service manual (87 pages) ,
- Setup and specifications (27 pages)
Table of Contents
Advertisement
Removing and installing components
NOTE:
The images in this document may differ from your computer depending on the configuration you ordered.
Recommended tools
The procedures in this document may require the following tools:
● Phillips screwdriver #0
● Phillips screwdriver #1
● Phillips screwdriver #2
● Plastic scribe
Screw list
NOTE:
When removing screws from a component, it is recommended to note the screw type, the quantity of screws, and
then place them in a screw storage box. This is to ensure that the correct number of screws and correct screw type is
restored when the component is replaced.
NOTE:
Some computers have magnetic surfaces. Ensure that the screws are not left attached to such surfaces when
replacing a component.
NOTE:
Screw color may vary with the configuration ordered.
Table 1. Screw list
Component
I/O cover
Display hinges
Hard-drive assembly
Hard-drive bracket
System-board shield
Wireless-card bracket
M.2 2230/M.2 2280 solid-state
drive
Solid-state drive screw mount
10
Removing and installing components
Screw type
Quantity
M3x5
5
M3x5
10
M3x5
1
M3x3.5
4
M3x5
4
M2x3.5
1
M2x3.5
1
M3x4
1
Screw image
2
Advertisement
Table of Contents
