Dell W29C Service Manual page 64

Steps
1. Slide and insert the display panel into the slot on the display-assembly base.
2. Route the display-backlight cable, touchscreen cable, and display cable on the display panel through the slots on the
display-assembly base.
3. Place the display-assembly base on a clean and flat surface with the display panel facing down.
4. Replace the 10 screws (M3x5) that secure the display panel to the display-assembly base.
5. Replace the five screws (M3x3) that secure the display panel to the display-assembly base.
NOTE: The screws that secure the middle frame and display panel to the display-assembly base are silver in color and
etched with "LCD" around the screw holes.
Next steps
1. Install the heat sink.
2. Install the M.2 2230 solid-state drive
3. Install the wireless card.
4. Install the memory module.
5. Install the system board.
6. Install the system-board
7. Install the hard drive.
8. Install the I/O cover.
9. Install the back cover.
10. Install the stand.
11. Follow the procedure in
64 Removing and installing components
or M.2 2280 solid-state
shield.
After working inside your
drive, as applicable.
computer.