Panasonic LUMIX DC-FT7 Operating Instructions For Advanced Features page 166

11. Using the Wi-Fi function
If you are not sure about the WPS compatibility (connecting by [From List])
• Confirm encryption key of the selected wireless access point if the network authentication is
encrypted.
1
Press 3/4 to select the wireless access point you
are connecting to, and press [MENU/SET].
• Pressing [DISP.] will search for a wireless access point
again.
• If no wireless access point is found, refer to "When
connecting with [Manual Input]" on P166.
2
(If network authentication is encrypted)
Enter the encryption key.
• For information on how to enter characters, refer to P44.
• Except for the first-time connection, a connection will be made automatically using the
previously-used encryption key.
When connecting with [Manual Input]
∫
• When connecting by [Manual Input], confirm SSID, authentication type, encryption type,
encryption key of the wireless access point you are using.
1 On the screen displayed in step
(connecting by [From List])", select [Manual Input] by pressing 3/4, then press
[MENU/SET].
2 Enter the SSID of the wireless access point you are connecting to, then select [Set].
• For information on how to enter characters, refer to P44.
3 Press 3/4 to select the network authentication type, and press [MENU/SET].
[WPA2-PSK]
[WPA2/WPA-PSK]
[No Encryption]
4 (When an option other than [No Encryption] is selected)
Enter the encryption key and select [Set].
• Check the wireless access points instruction manual and settings when saving a wireless
access point.
• If no connection can be established, the wireless access point's radio waves may be too
weak.
Refer to "Message Display"
• Depending on your environment, transmission speed between the camera and wireless
access point may decrease. In addition, the wireless access point may not be available for
use.
1
of "If you are not sure about the WPS compatibility
Supported encryption type: [TKIP], [AES]
(P181) and "Troubleshooting"
166
—
(P183) for details.