Exterior Lighting; Coming Home, Leaving Home Exterior Lighting; Light Assist High-Beam Assist System - Skoda KODIAQ 2019 Owner's Manual

50 Lighting, windscreen wipers and washers ›
Or:
Troubleshooting
Turn signal light defective
flashes faster - turn signal light on the right de-
fective
›
Check the turn signal light on the right.
flashes faster - turn signal light on the left de-
fective
›
Check the turn signal light on the left.
does not flash when the trailer is hitched -
trailer turn signal light defective
›
Check the trailer lighting.
Light bulb or LED bulb is defective
or illuminates
Information appears in the display regarding
the affected lights.
›
Replace the defective bulb.
›
In case of a defective LED bulb, contact a specialist
garage for help.
The headlights are misted up on the inside
Inside the headlights, moisture may occur. This is not
a defect.
Malfunction of the automatic headlight circuit
›
Clean the windscreen in the area of the rain/light
sensor.
Beam of light in front of the vehicle has shortened
Headlight defective.
›
Seek the help of a specialist garage.
Driving lights defective
If a message regarding the failed driving lights is dis-
played, the light will work in emergency mode.
›
Drive on, exercising appropriate caution.
›
Seek the help of a specialist garage.
COMING HOME, LEAVING HOME

exterior lighting

Functionality
The COMING HOME function turns on the light after
turning off the ignition and opening the driver's door.
The light switches off automatically after the set
lighting time has elapsed.

COMING HOME, LEAVING HOME exterior lighting

The LEAVING HOME function switches on the light
when unlocking the vehicle with the wireless remote
control.
Operating conditions
✓ Visibility has worsened.
✓ The light switch is in the
Settings
This function is set in the following menu in the Info-
tainment system.
Or:

Light Assist high-beam assist system

Functionality
The high beam assist system automatically switches
the high beam on and off.
WARNING
Risk of an accident!
If necessary, manually switch the high beam on or
▶
off.
Operating conditions
✓ The system is activated.
✓ The light switch is in the
✓ The driving speed is higher than 60 km/h (for
some countries, higher than 40 km/h).
✓ The low beam is switched on.
Operation
Switching on
Switching off
›
Manually switch the high beam on or off.
position.
position.
›
Push the lever in the
direction of the arrow.
in the instrument
cluster lights up.