Larson Electronics LEDSB-3XQF12V-1227-WF-3XKT Installation And Mounting Manual

Larson Electronics LLC
9419 E US HWY 75, Kemp, TX 75143 - P: 903-498-3363 F: 903-498-3364 E:
INSTALLATION AND MOUNTING

Magnetic Mounting:

WARNING:
As with any magnetically mounted warning device, its use on the exterior of a moving
vehicle is at the sole discretion and responsibility of the user.
This magnetic mount provides a secure, temporary installation in most circumstances and is
recommended for stationary use only.
The magnetic based beacon provides a secure, temporary installation. The beacon should be placed in
the center of the roof where the least amount of curvature occurs. Check the magnet for debris before
installation. Any foreign matter can reduce holding power and scratch the vehicle. The roof surface
should be dry and have a dull, not glossy finish. A glossy, highly waxed surface will reduce the magnet's
holding power. When placed, the beacon should adhere firmly. The user should not attempt to drive
with the beacon in place should the unit slide or move easily.
Voltage:
120-277 V AC Stepped Down to 10-30V DC

Permanent Mounting:

The permanent mount beacon provides a secure, permanent installation. Use the supplied foam
gasket and screws to mount the beacon in the desired location. Wire routing should be taken into
consideration when choosing a mounting location.

Pipe Mounting (optional):

The beacon base will accept a standard 1" NPT pipe. Hand tighten the beacon base on the pipe thread
until the pipe bottoms out inside the unit. DO NOT over tighten- Base is plastic.

WIRING INSTRUCTIONS

Magnetic Mounting:
The magnetic mount beacon is equipped with a light plug rocker switch, that plugs into a 12 Volt DC
cigarette lighter outlet; rotate and push with reasonable moderate force to insure the best possible
connection.
Permanent Mounting:
The beacon is terminated with a 6" long 4-wire cable harness that may be connected as follows:
Color
Red
Black
Blue
Yellow Synchronization
WWW.LARSONELECTRONICS.COM
LEDSB-3XQF12V-1227-WF-3XKT
Function
Power +VDC
Ground Chassis Ground
Pattern Switching Chassis Ground to Activate
See Synchronization Section
sales@larsonelectronics.com
Connect To