Starting The First Time Configuration Wizard - Check Point QUANTUM SPARK 1535 Getting Started Manual

Starting the First Time Configuration Wizard

To configure the 1535 / 1555 Appliance for the first time after you complete the hardware setup, use the First
Time Configuration Wizard.
WiFi models with a special device label only:
If you did not yet run the First Time Configuration Wizard, you can connect through WiFi using the SSID and
WiFi password that appears on the sticker. This is unique for each appliance.
If you do not complete the wizard because of one of these conditions, the wizard will run again the next time
you connect to the appliance:
The browser window is closed.
n
The appliance is restarted while you run the wizard.
n
After you complete the wizard, you can use the WebUI (web user interface) to change settings configured
with the First Time Configuration Wizard and to configure advanced settings.
To open the Appliance WebUI, enter one of these addresses in a web browser:
n http://my.firewall
n https://192.168.1.1:4434
If a security warning message shows, confirm it and continue.
The First Time Configuration Wizard starts.
Quantum Spark 1535 / 1555 Appliance Getting Started Guide | 19
Starting the First Time Configuration Wizard