Troubleshooting Guide - TEFAL OptiGrill+ GC712D34 Instructions Manual

Troubleshooting guide

Problem
blinking
Button
+ Indicator light solid green
+ Button blinking
The appliance stops during the cycle of
pre-heating or cooking.
The indicator light will blink white
+ Button / /
+ Intermittent beeping
The device does not beep.
The indicator light will blink white
+ Button blinking
+ Continuous beeping
After preheating, I placed the food inside and
closed the appliance,
light stays purple and cooking does not
begin.
The appliance will activate in manual mode
+ The indicator light will blink red.
+ button
temp control and
fixed
14
Cause
• Sw i tc h i n g o n t h e
appliance or starting an
automatic cooking cycle
with food and without
p l a t e s p r e h e a t i n g
(m a n u a l m o d e i s
automatically activated).
• The appliance has been
kept open for too long
while cooking.
• The appliance has been
idle too long after the
end of warm up or keep
warm.
• Appliance failure.
• Appliance stored or used
/ blinking
in a room that is too cold.
• Appliance failure.
• The quantity of food
but the indicator inside the appliance is
greater than 4 cm.
• The grill was not opened
completely when placing
the food inside.
The appliance does not
detect food inside The
quantity of food is
insufficient, " OK " is
blinking.
• Preheating time was cut
short.
light
Solution
• 2 possible options:
– Choose the temperature setting by
pressing the
press OK. Allow to cook, but you must
monitor the cooking (manual mode).
– stop the appliance, remove the food,
close the appliance properly, re-
program the appliance and wait until
end of preheating.
• Disconnect the appliance from the outlet
and leave for 2-3 mins., restart the process.
The next time you use the appliance,
make sure you open and close it quick for
best cooking results. If the problem occurs
again contact your local Tefal customer
service.
• Disconnect and reconnect your appliance
and immediately restart a preheat cycle.
If the problem persists, contact your
Customer Service.
• Unplug the appliance and contact
customer service.
• The quantity of food should not exceed
4 cm.
• Open the grill completely and close it
again.
• Confirm cooking activation by pressing
the button .
• Monitor the cooking periodically
(for use in manual mode).
Or
• Stop the grill, remove food, close the grill,
select the new cooking programme you
wish to use and wait for the preheating
cycle to finish.
button and then