Troubleshooting Guide - TEFAL GC7228 Instructions For Use Manual

Troubleshooting guide

Problem
Button
lit
Solid green indicator light
+
+ Button
flashing
+ Button
flashing
The appliance stops during the cycle of
pre-heating or cooking.
Flashing white indicator light.
/ / /
+
+ Dis continue bip
The appliance no longer beeps.
After the preheating, I have put my food
on the grill but the indicator stays on
PURPLE and the cooking cycle does
not start.
The appliance will activate in manual
mode
The indicator light will blink red.
+
Flashing white
button flashing
+
+ Continuous bip
Tip, especially for meat: the cooking results on the preset programs may vary depending on origin, cut and quality of
the food being cooked, the programs have been set and tested for good quality food.
Similarly, the thickness of the meat has to be taken into account during cooking; you cannot cook food that is thicker
than 4 cm.
42
Cause
• S w i t c h i n g o n t h e
• The appliance has been
• The appliance has been
• Appliance failure.
• Appliance stored or
button flashing
• Your food is thicker than
• You have not completely
• Not sensing the food.
• Preheating time was cut
• Appliance failure
appliance or starting
an automatic cooking
cycle with food between
p l a te s a n d w i t h o u t
p r e h e a t i n g ( m a n u a l
mode is automatically
activated).
kept open for too long
while cooking.
idle too long after the
end of warm up or keep
warm.
used in a room that is
too cold.
4 cm.
opened the grill to place
the food.
The food thickness too
thin, "OK" is flashing.
short.
Solution
• 2 possible options:
– Choose the temperature setting by
pressing the
press OK. Allow to cook, but you
must monitor the cooking (manual
mode).
– stop the appliance, remove the
food, close the appliance properly,
re-program the appliance and wait
until end of preheating.
• Disconnect the appliance from the
outlet and leave for 2-3 mins., restart
the process. The next time you use the
appliance, make sure you open and
close it quick for best cooking results. If
the problem occurs again contact your
local Tefal customer service.
• D i s c o n n e c t a n d r e c o n n e c t y o u r
appliance and immediately restart a
preheat cycle. If the problem persists,
contact your Customer Service.
• Food must not be thicker than 4 cm.
• Completely open the grill then close it.
• Confirm the start of the cooking by
pressing the button.
• Monitor the cooking periodically
(for use in manual mode).
Or
• Stop the grill, remove food, close the
grill, select the new cooking programme
you wish to use and wait for the
preheating cycle to finish.
• Unplug the product and contact your
customer service.
button and then