Troubleshooting Guide - TEFAL OptiGrill+ GC718D10 Instructions For Use Manual

Troubleshooting guide

Problem
Button blinking
+ Indicator light solid blue
+ Button
blinking
The appliance stops during the cycle of
pre-heating or cooking.
The indicator light will blink purple
+ Button
/ /
+ Intermittent beeping
The device does not beep.
The indicator light will blink purple
+ Button blinking
+ Continuous beeping
After preheating, I placed the food inside
and closed the appliance,
indicator light stays white and cooking
does not begin.
The appliance will activate in manual mode
+
The indicator light will blink red.
+ button temp control and
fixed
14
Cause
• Sw i t c h i n g o n t h e
appliance or starting
an automatic cooking
c y c l e
and without plates
preheating (manual
mode is automatically
activated).
• The appliance has been
kept open for too long
while cooking.
• The appliance has been
idle too long after the
end of warm up or keep
warm.
• Appliance failure.
• Appliance stored or used
blinking
in a room that is too cold.
• Appliance failure.
• The quantity of food
but the inside the appliance is
greater than 4 cm.
• The grill was not opened
completely when placing
the food inside.
• The appliance does
not detect food inside
The quantity of food
is insufficient, " OK " is
blinking.
• Preheating time was cut
short.
light
Solution
• 2 possible options:
– Choose the temperature setting by
w i t h f o o d
– stop the appliance, remove the
• Disconnect the appliance from the
outlet and leave for 2-3 mins., restart
the process. The next time you use the
appliance, make sure you open and
close it quick for best cooking results. If
the problem occurs again contact your
local Tefal customer service.
• Disconnect and reconnect your
appliance and immediately restart a
preheat cycle. If the problem persists,
contact your Customer Service.
• Unplug the appliance and contact
customer service.
• The quantity of food should not exceed
4 cm.
• Open the grill completely and close it
again.
• Confirm cooking activation by pressing
the button
• Monitor the cooking periodically
(for use in manual mode).
Or
• Stop the grill, remove food, close the grill,
select the new cooking programme you
wish to use and wait for the preheating
cycle to finish.
pressing the button and then
press OK. Allow to cook, but you must
monitor the cooking (manual mode).
food, close the appliance properly,
re-program the appliance and wait
until end of preheating.
.