Advertisement
5
MODEL NO. 085-1557-8
L-FT1047PST-F
Product size:∅38.9"XH19",When in use, keep cylinder at
least 30 in / 76.2 cm side clearance from fire pit table, DO
NOT trip over the gas pipe between fire pit and cylinder
when passing through, to prevent cylinder from tipping
over.
Inspect the hose assembly and burner prior to each use.
If there is evidence of excessive abrasion or wear or if the
hose or burner is damaged, it must be replaced with the
appropriate part from the manufacturer.
Inspect the gas connections of the appliance prior to
each use. Do not operate the unit if there is a gas leak. Have
the appliance inspected annually by a qualified service
person.
The pressure regulator and hose assembly provided with the appliance must be used. The replace-
ment part must be the same as the part specified by manufacturer.
For the assembly of LP-gas and leak checking please refer to "Gas Connection" on page 10 and
"Leak Test" on page 12.
Children and adults should be alerted to the hazards of high surface temperatures and should stay
away to avoid burns or prevent clothing ignition.
Young children and pets should be carefully supervised when they are in the area of the appliance.
Any guard or other protective device removed for servicing the appliance must be replaced prior
to operation.
Clothing or other flammable materials should not be hung from the appliance or placed on or near
the appliance.
Do not use the appliance if any part has been under water. Immediately call a qualified technician
to inspect the appliance and to replace any part of the control system and any gas control which has
been under water.
LP-gas supply cylinder to be used must be constructed and marked in accordance with the specifi-
cations for LP-gas cylinders of the Canadian. Department of Transportation (DOT).
The cylinder supply system must be arranged for vapour withdrawal and the cylinder must include
a collar to protect the cylinder valve.
Use only 20 lb / 9 kg LP-Gas cylinders.
Do not burn wood or any other materials in this appliance.
The appliance must be isolated from the gas supply piping system by closing its individual manual
shutoff valve during any pressure testing of the gas supply piping system at test pressure equal to or
less than 1/2 PSI (3.5 kPa).
Other cylinders may be acceptable for use with the appliance provided they are compatible with the
appliance retention means and accompanied by illustration(s) depicting the cylinder mounted to the
appliance utilizing the cylinder retention means and the point of contact between the cylinder and the
retention means.
Properly place the hose out of pathways where people may trip over it
or in areas where it may be subject to accidental damage.
The burner must be replaced prior to the appliance being put into
operation if it is evident that the burner is damaged. The replacement
burner must be the same as the part specified by manufacturer.
For cleaning of the appliance including the burner, please refer to
"Storage and Maintenance" on page 12.
Advertisement
