Table of Contents
Advertisement
The machine proceeds to run a rinse cycle; besides heating the
boiler, this serves to circulate hot water around the internal cir-
cuits so that they are warmed up as well.
Once the heating cycle has ended, the coffee beverage and
OK icons become active and light up; if the milk container (D3)
is in position, the icons indicating the milk beverages will also
be active.
5. TURNING THE APPLIANCE OFF
Whenever the machine is turned off after being used to make
coffee, it performs an automatic rinse cycle.
Danger of scalding!
During rinsing, a little hot water flows from the coffee spouts
(A9). Take care to avoid contact with splashes of water.
•
To turn the appliance off, press the
6);
•
If provided for, the appliance performs a rinse cycle then
goes off (stand-by).
Please note:
If you will not be using the appliance for some time, unplug it
from the mains socket:
•
first turn the appliance off by pressing the
(fig. 6);
6. SETTING WATER HARDNESS
For instructions on setting water hardness, see section "18. Set-
ting water hardness".
7. SETTING TEMPERATURE
To change the temperature of the water used for making coffee
(low, medium, high), proceed as follows:
1. With the machine off (in standby mode) but still plugged
into the electrical power supply;
2. Press and hold the icon
touch screen (B) light up;
3. Press the
icon (B10);
4. Press the icon again to select the desired temperature
6
button (A7) (fig.
button
(B9) until the indicators on the
5. Press the
OK icon (B15) to confirm (or
to exit without making any change).
The lights go off.
The appliance returns to "standby" and the temperature is now
programmed.
8. AUTO-OFF
THE time can be changed so that the appliance switches off after
being idle for 15 or 30 minutes, or after 1, 2 or 3 hours.
To re-programme Auto-off, proceed as follows:
1. With the machine off (in standby mode) but still plugged
into the electrical power supply;
2. Press and hold the icon
screen (B) light up;
3. Press the
icon (B11);
4. Press the
interval:
5. Press the
OK icon (B15) to confirm (or
to exit without making any change). The lights go off.
The auto-off time is now programmed.,
9. ENERGY SAVING
Use this function to enable or disable energy saving. This mode
is active by default, reducing energy consumption while the ma-
chine is on in compliance with current European regulations. To
change the setting, proceed as follows:
1. With the machine off (in standby mode) but still plugged
into the electrical power supply;
2. Press and hold the icon
touch screen (B) light up.
3. Press the
icon (B13);
4. Press the
icon again to enable/disable the function:
•
•
:
7
low
medium
high
(B9) until the icons on the touch
icon again to select the desired time
15 min.
30 min.
1 hour
2 hours
3 hours
(B9) until the indicators on the
function enabled
function disabled
ESC (B14)
ESC (B14)
Advertisement
Table of Contents
Troubleshooting
