Toro GrandStand 72520 Operator's Manual page 37

Charging the Battery
WARNING
Charging the battery produces gasses that
can explode.
Never smoke near the battery and keep sparks
and flames away from battery.
Important:
Always keep the battery fully charged
(1.265 specific gravity) to prevent battery damage
when the temperature is below 0°C (32°F).
1. Remove the battery from the chassis; refer to
Removing the Battery (page
2. Check the electrolyte level.
3. Ensure that the filler caps are installed on the
battery.
4. Charge the battery for 1 hour at 25 to 30 A or 6
hours at 4 to 6 A.
5. When the battery is fully charged, unplug the
charger from the electrical outlet, and disconnect
the charger leads from the battery posts
50).
6. Install the battery onto the machine and connect
the battery cables; refer to
(page 37).
Note:
Do not run the machine with the battery
disconnected; electrical damage may occur.
Figure 50
1. Positive battery post
2. Negative battery post
36).
(Figure
Installing the Battery
g000538
3. Red (+) charger lead
4. Black (-) charger lead
Installing the Battery
Install the battery as shown in
37
Figure 51.
Figure 51
g030989