Description Of The 1P Control Panel - Carbest ASR 680 SKEW Installation And Use Manual

4.2.

Description of the 1P control panel

Switching on
To switch on the system press the on/off (3) button on the control panel. When this but-
ton is pressed the red and green LED will simultaneously be switched on to check that
the LEDS are working correctly. After a few seconds the red LED will turn off and the
green LED will start to flash, to show that the system is searching for the satellite. Once
the satellite has been found and confirmed the green LED will stop flashing and remain
fixed The green LED will then begin to flash very quickly when the signal is recognized
and will go back to fixed mode as soon as the satellite is acknowledged.
Parking/switching off
To park and therefore switch off the satellite dish press the on/off (3) button for a few
seconds until the green LED starts to flash. This procedure must always be carried out
before travelling in order to close the satellite dish and put it back into position for travel-
ling. During this operation the green LED will keep flashing until the dish is completely
closed and will only stop flashing once the dish has been fully closed..
POWER SUPPLY LED (2)
USB PLUG FOR
RED ALARM LED
ON/OFF BUTTON (3)
REPROGRAMMING
Please note that for any warning signals you must read paragraph 6.4.1
14