Assembly Instructions Of The External Unit - Carbest ASR 680 SKEW Installation And Use Manual

2.1 Assembly instructions of the external unit

CAUTION! Read carefully the safety standards concerning installation before in-
stalling the device. The non-observance of these instructions may lead to dam-
age or serious injuries.
2.1.1 On the roof of the vehicle, find a sufficiently large area of roof (preferably
at the sides of the roof ) that allows for the positioning of the satellite dish (see
picture 2 )
CAUTION!!! When assembling the external unit, ensure that the bottom of the dish when
closed is facing the direction of travel (see picture 3)
To complete the installation of the external unit, apply a layer of adhesive around the fas-
tening plate in order to make it totally waterproof (see picture 4)
Note: leave the adhesive to set for 24 hours before moving the vehicle
2.1.2 Clean carefully the area of the roof selected for the in-
stallation of the external unit (remove oil, grease and
dust). Carefully clean the lower part of the fastening
plate in order to remove any trace of dust and grease.
2.1.3 With a silicon gun apply a homogenous layer of struc-
tural polyurethane adhesive at ambient temperature
in the lower part of the fastening plate (dekasyl MS-2
OR MS-5 glue is recommended; keep to the instruc-
tions for application).
2.1.4 Position the external unit on the previously
2
cleaned roof area. Push strongly on it in order to ensure
a good distribution and adhesion of the glue.
DIRECTION OF TRAVEL
7
4
3
GLUE
ROOF