Switching On; Satellite Search And Selection - Carbest ASR 680 SKEW Installation And Use Manual

4.3 Switching on

Press the on / off (3) button on the control panel.
When the button is pressed, the following LEDs will turn on in the LED version:
- green supply LED (2) showing the supply condition
- green LED (5) for the selected satellite will flash while the system searches for the satellite.
The LED light is green and stays on once the satellite dish has locked on to the satellite.
- the green power LED (2) turns on to show the power condition
- the display shows the name of the selected satellite that the system will automatically
search for.
Note: If the satellite dish is not in the parked position when the power is switched on, the
system will close the satellite dish instead of performing the search.

4.4 Satellite search and selection.

The system starts searching for the previously selected satellite as soon as it is
switched on.
If the satellite shown is not the one you want, press button (4) on the control panel
and:
a) Scroll through the list of stored satellites until you find the satellite you want (in
the display version)
b) Scroll through the different LEDs until the light on the LED of the satellite you
want turns on (LED version).
The system will automatically search for the selected satellite and will store its
position in order to facilitate and speed up subsequent searches.
If the satellite is not able to find the satellite after performing a full scan, the sys-
tem will set the satellite dish to its parked position.
16