Bluetooth App Association - Carbest ASR 680 SKEW Installation And Use Manual

6.5 BlueTooth app association

CONNECTION BY THE BOX
- Turn on the Bluetooth device and open the ASR application;
- Press and hold the "Association" button until a pop-up message opens;
- Check that the BOX is off and the antenna is closed;
- Press the ON button on the Box until you hear an acoustic signal;
-Press "Continue" on your device;
- When a new pop-up message appears, press "Continue";
- You will hear a confirmation beep for "complete association procedure", press "OK";
- Remove the power cable to the BOX for a few seconds and replace it;
- Turn on the BOX with the ON button;
- Click "Connect" from the application and wait a few seconds;
-When the upload is complete, the menu will open to select the preferred satellite.
CONNECTION BY THE BOX AND 7SAT DISPLAY
-Turn on the smartphone's Bluetooth and open the ASR app;
-Press and hold the "Association" button until a pop-up message opens;
-Switch the antenna on from the ON / OFF button of the display and wait for the complete
opening;
-Close the antenna with the dish closing button;
-Check that the green LED (upper left) is lit and fixed;
-Keep the "close antenna" button pressed, wait until all the red lights come on in sequence and
the box emits an acoustic signal;
-When a new pop-up message appears, press "Continue";
-Another pop-up message will appear, press "Continue" and then "OK";
-Press the ON / OFF button to turn off the antenna and switch it on again;
-Click "Connect" from the application and wait a few seconds;
-When the upload is complete, the menu will open to select the chosed satellite.
CONNECTION BY THE BOX AND 15SAT DISPLAY
-Turn on the smartphone's Bluetooth and open the ASR app;
-Press and hold the "Association" button until the pop-up message opens;
-Switch the antenna on from the ON / OFF button of the display and wait for the complete
opening;
-Close the antenna with the dish closing button;
-Check that the green LED (upper left) is lit and fixed;
-Keep the "close antenna" button pressed, wait for the display pixels to light up in sequence and
for the box to emit an acoustic signal;
-When a new pop-up message appears, press "Continue";
-Another pop-up message will appear, press "Continue" and then "OK";
-Press ON / OFF button to turn off the antenna and switch it on again;
-Click "Connect" from the application and wait a few seconds;-When the upload is complete, the
menu will open to select the chosed satellite.
24