Table of Contents
Advertisement
8.4 Extension Cords
USE PROPER EXTENSION CORD. Make sure
your extension cord is in good condition. When
using an extension cord, be sure to use one heavy
enough to carry the current your product will draw.
An undersized cord will cause a drop in line voltage
resulting in loss of power and overheating. Table 1
shows correct size to use depending on cord
length and nameplate ampere rating. If in doubt,
use the next heavier gauge. The smaller the gauge
number, the heavier the cord.
Recommended Gauges (AWG) of Extension Cords
Amp Rating
Volts
Total length of cord in feet
Not
120
25
More
240
50
More
Than
Than
0
6
18
6
10
18
10
12
16
12
16
14
Table 1
8.5 Magnetic Switch and Safety Key
Refer to Figure 15.
The start switch has a power indicator lamp which
is on whenever there is power connected to the
saw, not just when the saw is running. Always
check before use.
Do not assume that no light
means there is no power to the machine. If the
bulb is bad, there will be no indication. Always
check for power first. Failure to comply may
cause serious injury!
To start saw, pull red button. Push it back in to stop
saw.
The switch has a safety key (Figure 15). Slide key
out and store in a safe place, to prevent
unauthorized starting of saw. Reinstall key to
operate saw.
Figure 15
50
100
150
100
200
300
AWG
16
16
14
16
14
12
16
14
12
12
Not Recommended
9.0 Adjustments
industrial-grade low-friction corrosion-resistant
coating on the table and table extensions.
While the coating is durable, it can be damaged
if metal or other hard and/or sharp objects
strike,
gouge,
Significant damage to the coating may affect its
performance.
Use
adjustments to this saw.
9.1 Tools Required for Adjustments
Hex keys – 3, 4, and 8mm
Wrenches – 11 and 12mm
Straight edge
Combination square
source before making adjustments.
9.2 Fence Alignment
Before using the Accu-Fence
properly aligned with the blade. Consult the fence
manual, no. M-2195075Z.
9.3 Blade Raising/Tilt Mechanism
Refer to Figure 16:
To raise or lower blade, loosen lock knob (A) and
turn handwheel (B) on front of saw until desired
height is reached. Tighten lock knob. The blade
should be adjusted about 1/8" above top surface of
material being cut.
To tilt blade, turn lock knob (C) counterclockwise to
loosen, turn handwheel (D) until desired angle is
obtained, as shown on tilt scale. Retighten lock
knob (C).
9.4 Miter Gauge
Refer to Figures 17, 18, 18B, and 18C.
For model PM1000T: The miter
gauge has non-marring bottom surfaces to
protect the industrial-grade low-friction table
coating. To prevent damage to the table
coating, only use the miter gauge supplied with
this machine.
16
Model
PM1000T
has
or
scratch
the
surface.
care
when
Disconnect saw from power
®
, verify that it is
Figure 16
an
making
Advertisement
Table of Contents
