Table of Contents
Advertisement
needed. Tighten the screws with the hex
wrench.
2. Install the guide rail to the bottom holes in the
front rail, using three (3) M6x16 socket head
button screws (HP-1), with M6 lock washers
(HP-4) and M6 flat washers (HP-3). Hand-
tighten only. Pull the guide rail away from the
table as far as it will go, then tighten all five (5)
screws in the guide tube with the hex wrench.
Do not overtighten.
3. Install the table pin (HP-7) to the front edge of
the table and connect the table pin tether to the
table using the provided screw (HP-2).
Figure 5a
7.9 Install Handwheel
Refer to Figure 5b.
Install the handwheel (A) onto the shaft (B). Align
the set screw on the handwheel with the flat side of
the shaft and tighten with the hex key.
Figure 5b
8.0 Adjustments
industrial-grade low-friction corrosion-resistant
table coating. While the coating is durable, it can
be damaged if metal or other hard and/or sharp
objects strike, gouge, or scratch the surface.
Significant damage to the coating may affect its
performance.
adjustments to this machine.
Tools required for adjustments:
• Machinist square
• Cross point (Phillips) screwdriver
• Hex keys, 4mm/5mm/6mm
• 13mm wrench
• Straight edge and gauge
8.1 Fence Assembly
Refer to Figure 5c.
HP-2
Place fence body onto guide tube, as shown in
HP-7
Figure 5c. Raise fence lever all the way up to install
or remove fence from guide rail. Midway lever
position allows fence to slide along guide rail.
Lowest lever position locks fence in place.
8.2 Fence Plate
Refer to Figures 6 and 7.
Loosen lock bar (A) using knobs (B). Pull out on lock
bar until it protrudes enough on which to slide the
aluminum fence plate from one end, as shown in
Figure 6. Retighten knobs.
12
Model
PM1500T
Use
care
when
Figure 5c
Figure 6 – vertical position
has
an
making
Advertisement
Table of Contents
