Mounting Rails & Accu-Fence; Optional Wood Extension Table; Splitter And Guard Assembly; Motor Cover - Powermatic 72A Instruction Manual & Parts List

MOUNTING RAILS & ACCU-FENCE
With the extension wings properly aligned, the rail and
fence assembly can now be mounted to the saw.
Consult the separate Accu-Fence manual for instruc-
tions.

OPTIONAL WOOD EXTENSION TABLE

For instructions on mounting the accessory wood ex-
tension table, or router table, consult your Accu-Fence
manual.

SPLITTER AND GUARD ASSEMBLY

1. Insert the grooved end of the splitter support shaft
through slot in rear of saw and into hole in trunnion.
See Figure 6. Make sure the square head setscrew
(A) is backed out enough to allow easy insertion. See
Figure 7.
2. With a 3/8 wrench, reach through the motor open-
ing in the stand and tighten the square head setscrew
(A) into the groove of the shaft as shown in Figure 7.
(NOTE: The groove will be in the proper position if the
end of the shaft is made flush with the opposite side of
the trunnion hole.)
3. The upright member of the rear splitter support
(B) must be oriented toward the right of the shaft, as
observed from the rear of the saw. See Figure 8.
4. Mount the splitter assembly to the two adjusting
screws. See Figure 8. Place the two flanges of the
splitter assembly onto the screws as shown. Snug
the screws. (NOTE: Make sure the front shield (C)
faces in toward the blade)
5. The splitter and guard assembly must be aligned
with the blade before operating the saw. Adjust the
splitter according to the directions on page 13, "Split-
ter Alignment."

MOTOR COVER

The motor cover is attached to the cabinet with two
1/4-20 x 3/4 sheet metal screws. See Figure 9. The
cover's bottom lip rests inside the cabinet ledge.
10
FIGURE 6
FIGURE 7
FIGURE 8
FIGURE 9