Indicators On The Device - Fujitsu ESPRIMO K5010 Operating Manual

Operation

Indicators on the device

The indicators are on the front or on the left side of the case.
No. indicator
1 Multimedia module LED
indicator (optional)
2 Hard disk indicator
3 Power-on indicator
4 SmartCard reader
status indicator or
optical drive (depending
on the variant ordered)
In an energy-saving mode the device must not be switched off with the main switch
or disconnected from the mains supply, as this may result in data loss.
30
1
3
2
Description
The LED lights up blue when the camera is active.
The indicator lights up when the hard disk drive in the device
is being accessed.
• The indicator is illuminated:
The device is switched on.
• The indicator is flashing:
The device is in energy-saving mode. After being switched on
with the ON/OFF switch, the device powers up or returns to the
state it was in before it entered energy-saving mode.
• The indicator is not illuminated:
The device is switched off (disconnected from the mains) or is
ready to operate. If the device is ready to operate, it can be
switched on with the ON/OFF switch.
The indicator will light up when the SmartCard reader or the optical
drive of the device is being accessed.
You should never, under any circumstances, remove the SmartCard
or the CD/DVD while the indicator light is on.
4
Fujitsu