Table of Contents
Advertisement
Installation option - converting
from desktop to wall mount position
To mount the telephone base on the wall
1. Set aside the handset. On the telephone
base cradle, place a coin in the slit of the wall
mount clip and rotate a half turn
(180 degrees).
• It locks into place with the protruding
edge pointing towards the upper edge of
the telephone base. This protruding edge
holds the corded handset when the phone
is mounted on the wall.
2. Unplug the telephone line cord from the
telephone wall jack. Then press the large tab
on the upper groove on the telephone base.
3. Turn the mounting bracket upside down.
Remove the telephone line cord from the
wire duct and then route it through the
groove on the bottom part the mounting
bracket. Insert the small tabs on the mounting
bracket into the upper slots on the telephone
base. Then press the large tab on the
mounting bracket and firmly push it into the
lower groove on the telephone base.
4. Mount the telephone base on the wall by
aligning the eyelets with the mounting studs
of the wall plate. Then slide the telephone
base down on both mounting studs until it
locks into place. Place the handset on the
telephone base cradle.
EN - 11
Advertisement
Table of Contents
