Advertisement
WARNING
Always disconnect the stapler from the air supply before ANY KIND of adjustment, clearance
of jams, service, cleaning, re-locating and during non-operation.
Always wear safety goggles with side shields and hearing protection. Employers and users
are responsible for ensuring anyone near the stapler is also protected.
When the stapler is being loaded or is connected to the air compressor, never place your
hand or any other body part in the staple discharge area.
Use only parts and fasteners recommended by specification. Do not modify the stapler
without authorization.
CAUTION
Do not throw the tool, strike the body in any way or use the tool as a hammer to knock
material in place.
NOTE
Do not use the tool if it is not loaded, as this will accelerate wear on the stapler.
Make sure all hoses and fittings are free from damage and dirt, replacing any necessary
items.
LUBRICATION AND MAINTENANCE
CAUTION: Do not store the stapler in cold weather as the valves and mechanisms may
freeze up, causing the tool to operate incorrectly.
Be sure to disconnect the stapler from the air supply before lubricating.
The stapler must be lubricated before the first use, and before and after each additional use.
Oiling prevents rust and extra wear. Manual lubrication can be skipped if an Oiler is used.
An Oiler conveniently provides oil circulation that also increases the efficiency and life of the
tool. An Oiler should be used if the stapler is used heavily or constantly. The Oiler should be
checked daily for oil level.
NOTE
If operating in cold weather or below freezing, use permanent antifreeze as a lubricant.
Some drying agents may damage o-ring and seals, be sure to check these.
4
Advertisement
