Makita AN450H Technical Information

T
ECHNICAL INFORMATION
Models No.
Description
C
ONCEPT AND MAIN APPLICATIONS
Model AN450H is a pneumatic nailer powered by high pressure air;
designed for roofing shingles - especially for roofing asphalt shingles.
Drives the same wire collated coil nails as used for our normal pressure
air model AN453.
Its main benefits are:
Compact and lightweight design for high maneuverability
Nailing mode selector for providing Bump-fire
*
Sequential capabilities.
2
*1:
Nails can be fired one after the other continuously first by pulling Trigger
then by bumping Contact arm against workpiece with the Trigger pulled.
*2:
One nail is fired first by pushing Contact arm against workpiece, then by
pulling Trigger with the Contact arm kept pushed; nail cannot be fired when
the steps are reversed. Another one can be fired by releasing Trigger,
then by repeating the steps; however, cannot be fired if Trigger is not released
before repetition of the steps.
S
pecification
Nail type
Nail length: mm (")
Nail
Nails per coil
Magazine capacity
Operating air pressure: MPa
Net weight: kg (lbs)
S
tandard equipment
Hook ................................................................. 1
Safety goggles ................................................... 1
Oil supply (containing 30ml of turbine oil) ...... 1
Hex wrench 4 ................................................... 1
Plastic carrying case ......................................... 1
Note: The standard equipment for the tool shown above may vary by country.
O
ptional accessories
Air leak repair set
Coil nails
Air hose, etc.
AN450H
Pneumatic Roofing Coil Nailer
*
Wire collated coil nail
(3/4, 7/8, 1, 1-1/4, 1-1/2, 1-3/4)
(kgf/cm )
2
[PSI]
or
1
19, 22, 25, 32, 38, 45
120 nails
120 nails
1.28 - 2.26
(13 - 23)
[180 - 320]
2.2 (4.8)
PRODUCT
P 1/ 16
L
H
W2
W1
Dimensions: mm (")
Length (L) 287 (11-1/4)
Width 1 (W1) 142 (5-5/8)
Width 2 (W2) 117 (4-5/8)
Height (H) 276 (10-7/8)
Width 1: with Hook
Width 2: without Hook