Advertisement
AIR COMPRESSOR AND CONNECTIONS
NOTE: The air pressure required depends on fastener size and type of material to be stapled.
Never exceed the air pressure recommended by specifications.
If staples do not drive down tightly, adjust to a higher pressure setting until satisfactory.
Reduce air pressure if the fasteners are being driven too deeply.
Adding Quick Connector on the stapler and Quick coupler on the air hose can improve
performance.
WARNING OF DRIVING STAPLES
During the process of assembling the AIR HOSE, do not put your finger into the TRIGGER.
• It could cause the risk with an unexpected firing
Please get the DRIVER GUIDE tight on woods and then driving the TRIGGER.
• The staples can be driven with the driving the TRIGGER
OPERATING THE STAPLER
Add a few drops of high speed spindle oil or air tool oil into the air inlet.
Check the operation of the trigger, and load staples into the magazine.
Connect the stapler to the air compressor.
Test the depth of staples by driving staples into a sample piece of wood. If the staples do not
reach the desired depth, adjust the air pressure.
5
Advertisement
