Entering The Menu - Lochinvar EFW 85 Installation, Commissioning, User And Maintenance Instructions

Starting the water heater.
If the water heater is not on make sure the gas switch beneath the water heater is open and the power cord is
connected to the mains, use the on/off button to switch the water heater on. The following screen will occur:
This screen is active during power up until communication with the main Control has been established.
After communication has been established the Dair mode is running and the following screen appears:
Dair Running
The "De-Air" sequence is a safety function that starts at every power-up and is used to remove the air from the
heat exchanger. The De-Air sequence takes around 14 minutes to complete. It can be cancelled by pressing the
Enter button for over 5 seconds.
After completion or manual ending the "De-Air" sequence one of the following Status overview screens appears:
24.6.1 E
NTERING THE MENU
Enter the menu by pressing the MENU
menu. While scrolling through the menu you will see that the selected menu item is shown in a white rectangle.
Domestic Hot Water (DHW)
Information
Settings
System Test
Enter a menu item by pressing CONFIRM
The header shows your location inside the menu, as seen in the following image:
Domestic Hot Water (DHW)
DHW Store Setpoint
Use "DHW Store Setpoint" to set the Hot Water temperature
If you are inside the menu (or a menu item) and want to return directly to the Status overview press
MENU or ESC If you want to go back one step in the menu press BACK/LEFT ← .
button once. The header in the display shows you are inside the main
or RIGHT →.
50.0°C