Kohler 1835-GW-0 Installation And Care Manual page 17

Air Flow Mode
Activates Mode Selected
Rotate Outer Ring to
Access Desired Mode
Power On/Off
Chromatherapy Specific
Color (if provided)
Operating Instructions - Bath
NOTE: If the unit does not function properly, please refer to the "Troubleshooting" section.
Starting the Unit
Fill the bath to a level at least 4" (102 mm) above the top of the airjets.
Use your hand to test the water temperature for comfort and safety.
Carefully enter the bath basin.
Press the On/Off icon on the user keypad.
If desired, adjust the air flow rate using the up or down buttons.
Selecting Air Flow Modes
Rotate the outer ring to select a desired mode.
Press the "OK" icon to activate the mode.
To turn off a mode, rotate the outer ring until the icon is flashing green and then press the "OK"
icon again.
The icon will then turn blue, indicating the mode is off.
Stopping the Bath
When ready, press the On/Off icon a second time to stop the air system.
Carefully exit the bath.
When the bath drains below the level sensors an automatic, two-minute purge cycle occurs. The air
system then operates at low speed to blow any residual water out of the air harness.
Initiating a Manual Purge Cycle (when desired)
NOTE: Follow these steps if you choose to manually purge residual water from the air system.
After stopping the air system and draining the bath, rotate the ring on the user keypad to the
"Purge" icon.
When the "Purge" icon is flashing blue, press the "OK" icon once.
The "Purge" icon flashes green and the manual purge mode begins. The air system operates at low
speed to blow any residual water out of the air harness.
After two minutes, the air system stops automatically.
Kohler Co.
Zone 1
Zone 2
Zone 3
Chromatherapy Cycle (if provided)
17
Surge Mode
Increase Flow or Surge
Indicator Bar
Decrease Flow or Surge
Purge Mode
1204120-2-A