Pro-Form PFTL39115.3 User Manual page 12

9. Attach the Latch Assembly (42) to the Left
Upright (73) with two #10 x 1" Screws (7); start
both Screws, and then tighten them.
10. Attach the Right Handle Holder (23) to the Right
Upright (95) with two M4.2 x 15mm Screws (79).
Be careful not to overtighten the Screws.
Then, attach the clip (F) to the lower end of the
Right Upright (95), and set the handle of the
Resistance Cord (91) in the Right Handle Holder
(23).
Repeat the above steps on the left side of the
treadmill (not shown).
11. Make sure that all parts are properly tightened before you use the treadmill. To protect the floor or car-
pet, place a mat under the treadmill. To avoid damage to the console, keep the treadmill out of direct sunlight.
Keep the included hex keys in a secure place. One of the hex keys is used to adjust the walking belt (see
page 21). Note: Extra parts may be included.
9
73
42
7
10
79
12
91
23
95
F