Pro-Form PFTL39115.3 User Manual page 11

7. With the help of a second person, hold the con-
sole assembly (B) near the Right Handrail (81).
Insert the Upright Wire (71) through the three
looped Wire Ties (75).
Next, connect the ground wire (D) from the con-
sole assembly (B) to the Console Ground Wire
(80) on the Pulse Crossbar (97).
See the inset drawing. Connect the Upright
Wire (71) to the console wire (E). The connec-
tors should slide together easily and snap
into place. If they do not, turn one connector
and try again. IF YOU DO NOT CONNECT THE
CONNECTORS PROPERLY, THE CONSOLE
MAY BECOME DAMAGED WHEN YOU TURN
ON THE POWER.
8. Attach the console assembly (B) with ten
M4.2 x 15mm Screws (79); start all ten Screws,
and then tighten them. Be careful not to over-
tighten the Screws and make sure that no
wires are pinched.
Next, insert the wires into the console assem-
bly (B). Then, tighten the three Wire Ties (75)
around the wire and cut off the ends of the Wire
Ties.
7
B
81
75
8
75
79 79
11
E
75
D
71
80
E
97
71
B
79
79
79
79