Daikin FTXA35A2V1BW Operation Manual page 12

4 Operation
To connect the wireless adapter to your home
network
The wireless adapter can be connected to your home network using
the:
▪ WPS button on the router (if present),
▪ SSID and KEY number located on the unit.
To connect using the WPS button
1 Hold for at least 5 seconds in the default screen.
Result: The confirmation display (menu ) appears.
2 Press repeatedly or
(menu ) appears.
3 Press to confirm the selection.
Result: is blinking. The timer LED is blinking.
4 Press the WPS button on your communication device (e.g.
router) within approximately 1 minute. Refer to the manual of
your communication device.
INFORMATION
If the connection with your router is not possible, try
procedure "To connect
number" [ 4 12].
5 Press to exit the menu.
Result: The display will return to the default screen.
To connect using SSID and KEY number
1 Hold for at least 5 seconds in the default screen.
Result: The confirmation display (menu ) appears.
2 Press repeatedly or
) appears.
3 Press to confirm the selection.
Result: is blinking. The operation and timer LEDs are blinking
alternately.
4 Connect your smart device to the access point in the same way
as to a standard wireless network.
5 Enter the SSID number and password located on the unit or in
the accessory set.
6 Open the Daikin Online Controller application and follow the
steps on the screen.
Result: Wireless adapter mode will automatically change from
the AP mode to the RUN mode, the timer LED is blinking.
7 Press to exit the menu.
Result: The display will return to the default screen.
Operation manual
12
until the WPS setting display
using SSID and KEY
until the AP mode display (menu
To reset the connection setting to the factory
default
Reset the connection setting to the factory default in case you want
to:
▪ switch between the WPS and the AP connection option,
▪ disconnect the Wi-Fi adapter and the communication device (e.g.
router) or smart device,
▪ repeat the setting if the connection was unsuccessful.
1 Hold for at least 5 seconds in the default screen.
Result: The confirmation display(menu ) appears.
2 Press repeatedly or
appears.
3 Hold for at least 2 seconds to confirm the selection.
Result: is blinking. The setting is reset to the factory default.
4 Press to exit the menu.
Result: The display will return to the default screen.
To turn off the wireless connection
You can turn off the wireless connection using:
▪ the wireless adapter ON/OFF button on the unit,
▪ the user interface.
To use the wireless adapter ON/OFF switch
1 Press the wireless adapter ON/OFF switch.
Result: The wireless adapter communication is OFF.
Note: Press the ON/OFF switch again to turn on the wireless
adapter.
To use the user interface
1 Hold for at least 5 seconds in the default screen.
Result: The confirmation display (menu ) appears.
2 Press repeatedly or
3 Hold for at least 2 seconds to confirm the selection.
Result: is blinking. Communication is OFF.
4 Press to exit the menu.
Result: The display will return to the default screen.
CTXA15+FTXA25~50(A)(B)2V1B(W)(S)(T)(B)
until the A display (menu )
until the OFF menu appears.
Daikin room air conditioner
3P485919-7P – 2019.10