Mitsubishi Electric Trane TE-200A Installation Manual page 23

Procedure
Network settings
Group settings
*3
Other initial settings
Exiting the [Initial
Settings] screen
*1 When the [AE-200 Apportion] setting is set to [Use], the [AE-200 M-NET] setting is fixed to [Do not use].
*2 [Exp(1-4)] when the [AE-200 M-NET] setting on the [Unit info.] screen is set to [Do not use].
*3 When using an apportioned electricity billing function, refer to the Instruction Book that comes with the "Charge" license for details.
WT09302X01
System
configuration
1 2
Touch the [Network] tab in the [Initial Settings] menu.
① ①
Set the TE-200's IP address and other necessary settings, and touch [Save
② Settings].
* The TE-200 will restart.
Make sure that [AE200] is selected as [Controller], set the TE-200's IP address
and other necessary settings, and touch [Save Settings].
②
* The TE-200 will restart.
Touch the [AE200] button to change it to [Exp(1–3)]
③
IP addresses and other necessary settings, and touch [Save Settings].
① ① Touch the [Groups] tab in the [Initial Settings] menu.
② Make group settings for TE-200, and touch [Save Settings].
Make sure that [AE200] is selected as [Controller], make group settings for TE-200,
②
and touch [Save Settings].
Touch the [AE200] button to change it to [Exp(1–3)]
③
TE-50 controllers, and touch [Save Settings].
Make the following settings as necessary.
● Interlock settings (interlocked operation between LOSSNAY and indoor units)
① ① ● Block settings
● Floor Layout settings
● User Information settings
① ① Touch the
Details
icon to return to the [Monitor/Operation] screen.
23
*2 , set the TE-50's destination
*2 , make group settings for