Install And Remove Usb Port; Install Usb Port - Fujitsu S540 Operating Manual

► Press the front panel in the direction of the arrow (5) until the catches
(a) are felt to engage in the casing.
► Refit the casing cover on the casing (see chapter

Install and remove USB port

Depending on the configuration level of your device, there may be a location intended
for a USB port on the rear panel of the device.

Install USB port

► Remove the casing cover (see chapter
2
► Put the USB port into position with the board side upwards on the inside
of the device at the flagged location (1).
► Secure the USB port using the 2 x M2.5 screws provided (3), max. torque 0,4 Nm.
► Connect the cable of the USB port to the connector on the mainboard (3).
► Refit the casing cover on the casing (see chapter
Fujitsu
"Closing the casing", Page
"Opening the casing", Page
1
"Closing the casing", Page
System expansions
49).
30).
3
49).
39