Motorola 3260FAST User Manual page 131

Table A-1.
AT Commands, Cross-Referenced to Front Panel Options (Continued)
AT Parameter &
Command Option
ATIn —
Volume
ATL0/ATL1 =Soft
ATL2 =Medium
ATL3 =Loud
Speaker
ATM0 =Off
ATM1 =Dialing
ATM2 =On
ATM3 =Security
ATO0 —
ATO1 TEST=Retrain
Dial
ATP =Pulse
RsltCode
ATQ0 =Enable
ATQ1 =Disable
ATQ2 =Orig
S-Regxxx
ATS =nnn
Dial
ATT =Tone
RsltForm
ATV0 =Numeric
ATV1 =Verbose
Call Progress
ATX0 =0
ATX1 =1
Gray shading indicates country-specific options. See Appendix C for your country's options.
A-8 Configuration Quick Reference
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Description
Display Software Information (n= 0, 1, 2, 9)
0=displays 960
1=displays 000
2=displays OK
9=displays reason for last disconnect
These messages are sent with OK, when AT command processing is complete.
Speaker Volume
The speaker volume is set to soft.
The speaker volume is set to medium.
The speaker volume is set to loud.
Speaker Control
The speaker is always off.
The speaker is on when dialing and training, and off when the modem enters data mode.
The speaker is always on.
The speaker is on when dialing is complete and off when the modem enters data mode.
Retrain
The modem leaves command mode and returns online (to data mode).
The modem leaves command mode, returns online, and initiates a retrain with the remote
modem.
Dial Type
The modem uses pulse dialing unless otherwise specified by the T or P modifiers.
Result Codes
Result codes are displayed at the DTE.
Result codes are not displayed at the DTE.
Result codes are output to the DTE only when operating as an originate modem.
S-Register
Lets you view and set S-Registers (where xxx equals the S-Register to change and nnn equals
the value of the register). The value must be within the specified range (see Chapter 5 for a full
description of S-Registers).
Dial Type
The modem uses tone dialing unless otherwise specified by the T or P modifiers.
Result Code Format
Result codes are sent to your DTE as numbers (short form).
Result codes are sent to your DTE as full words (long form).
Call Progress
Determines whether the modem waits for call progress signals or blind dials when establishing
calls.
The modem uses only NO CARRIER and CONNECT result codes.
The modem uses only NO CARRIER, CONNECT, and CONNECT <Rate> result codes.