Specifications; Attachments/Accessories - Toro 30839N Operator's Manual

Parking Brake
Whenever the engine is shut off, engage the parking brake
(Figure 13) to prevent accidental movement of the machine.
To engage the parking brake, pull up on the lever. The engine
will stop if you press the traction pedal with the parking brake
engaged.
Lift Lever Lock
Move the lift lever lock (Figure 13) rearward to prevent the
cutting units from dropping.
Fuel Gauge
The fuel gauge (Figure 14) registers the amount of fuel in
the tank.
Figure 14
1. Fore and aft lever
Fore and Aft Seat Adjustments
Move the lever (Figure 14) on the side of the seat outward,
slide the seat to the desired position, and release the lever
to lock the seat into position.
2. Fuel gauge

Specifications

Note: Specifications and design are subject to change
without notice.
Overall Width - 68 inch width
of cut
Overall Width - 72 inch width
of cut
Length
Height to top of ROPS
Wheel Base
Track Width
Ground Clearance
Weight with cutting units

Attachments/Accessories

A selection of Toro approved attachments and accessories are
available for use with the machine to enhance and expand
its capabilities. Contact your Authorized Service Dealer or
Distributor or go to www.Toro.com for a list of all approved
attachments and accessories.
16
71.8 inches (182 cm)
75.8 inches (193 cm)
116 inches (295 cm)
70.8 inches (180 cm)
58.5 inches (149 cm)
57 inches (145 cm)
6 inches (15.3 cm)
2,124 lb (963 kg)