Connecting Serial Interface To Pc - AudioCodes Mediant 500Li Metal MSBR Hardware Installation Manual

Cabling the Device
◼
◼
Cable specification:
Cable: Standard straight-through RJ-11 telephony cable
◼
◼ Connector: RJ-11
◼ Connector Pinouts:
To connect an FXS interface:
1. Connect one end of an RJ-11 cable to an FXS port, located on the rear panel and labeled FXS.
2. Connect the other end of the cable to the required telephone interface (e.g., fax machine,
dial-up modem, or analog POTS telephone).
6.5

Connecting Serial Interface to PC

The device provides an RS-232 serial interface port on its rear panel. The RS-232 interface port is used
to access the device's command line interface (CLI). An RJ-45 to DB-9 serial cable adapter needs to be
ordered for serial cabling:
FXS interface is a customer-ordered item which is supported only on specific
hardware configurations. For more information, contact your AudioCodes sales
representative.
The FXS interfaces support loop-start signaling (indoor only).
Figure 18: RJ-11 Connector Pinouts for FXS Interfaces
Figure 19: Cabling FXS Interfaces
- 25 -
Mediant 500Li