Advertisement
7.
Attach to Strut 170 to Wall
Drill 1/2" diameter hole. Hold metal
A
channel flat alongside plastic straps
and slide channel through hole.
Snap straps at wall by pushing side
C
to side,snapping of straps level with
flange of cap.
Strut 170 Wall Stand Designed for Microsoft Surface 2S 50"
Install wall fasteners
to marked locations
and fasten.
Hold ends of straps between thumb
B
and forefinger and pull toward you
until channel rests flush behind wall.
Slide plastic cap along straps with either
hand with flange of cap is flush with wall.
Move Strut 170 to wall and attach
D
bracket. Insert bolt through Bracket
and tighten until snug against wall.
NOTE: Alternate fasteners
provided for wood studs.
501-760-MS v1.23
page 7 of 8
Advertisement
