Table of Contents
Advertisement
Quick Links
Strut Wall 170
ASSEMBLY INSTRUCTIONS
1.
Set Strut 170 in Place
Strut Wall 170 Instructions
B
Mark the wall.
(STR170/FH1)
A
Use leveler feet to level the unit.
Loosen nut with supplied wrench
and tighten to the locked position.
LIMITED WARRANTY
Salamander is proud to stand behind our products with industry-leading
warranties. Should you ever encounter any problem with your Salamander
product, let us know. We are here to make it right. 1.800.535.5659.
Full warranty including limitations and warranty claim information may be
found at www.salamanderdesigns.com/commercial/warranty
501-760 v5.22
page 1 of 9
Advertisement
Table of Contents
Related Manuals for Salamander Designs Strut Wall 170
Summary of Contents for Salamander Designs Strut Wall 170
- Page 1 Should you ever encounter any problem with your Salamander product, let us know. We are here to make it right. 1.800.535.5659. Full warranty including limitations and warranty claim information may be found at www.salamanderdesigns.com/commercial/warranty Strut Wall 170 Instructions 501-760 v5.22 page 1 of 9...
- Page 2 811 BLUE HILLS AVE. - ALL THREADS TO BE CLASS 2 BLOOMFIELD, CT 06002 - COUNTERSINK ALL TAPPED HOLES Strut Wall 170 Instructions 501-760 v5.22 page 2 of 9 /T/ 860.313.0525 /F/ 860.313.0526 - DEBURR HOLES AND BREAK SHARP EDGES...
- Page 3 Bottom Screw Position display mount panel to the desired height by aligning the two top screws to the appropriate holes in the post and tighten all four screws. Strut Wall 170 Instructions 501-760 v5.22 page 3 of 9...
- Page 4 Removing Lift-Off Panels Lift panels up and off, leaving the lift off panel screws. Remove the panel lock thumb screws on the lift-off panels from the backside of unit. Strut Wall 170 Instructions 501-760 v5.22 page 4 of 9...
- Page 5 Reinstall Lift-Off Panels Depending on lift-off panel positions, screws may need to be repositioned. See diagram to locate appropriate position. Strut Wall 170 Instructions 501-760 v5.22 page 5 of 9...
- Page 6 If using 2 peripherals, with one above and below, use a combination of 1 and 2 post mounts as shown. These can be either 1 post over 2 , or 2 posts over 1. Tech Shelf Tech Bracket Strut Wall 170 Instructions 501-760 v5.22 page 6 of 9...
- Page 7 Snap straps at wall by pushing side Move Strut 170 to wall and attach to side,snapping of straps level with bracket. Insert bolt through Bracket flange of cap. and tighten until snug against wall. Strut Wall 170 Instructions 501-760 v5.22 page 7 of 9...
- Page 8 Attach Brackets to Display Use holes shown. Install Display Insert the four shoulder washers on the brackets through the keyhole openings and rest washers at the bottom of the openings. Strut Wall 170 Instructions 501-760 v5.22 page 8 of 9...
Need help?
Do you have a question about the Strut Wall 170 and is the answer not in the manual?
Questions and answers