Advertisement
Quick Links
Strut 170 Wall Stand Designed for
Microsoft Surface 2S 50"
ASSEMBLY INSTRUCTIONS
1.
Set Strut 170 in Place
Strut 170 Wall Stand Designed for Microsoft Surface 2S 50"
B
Mark the wall.
A
Use leveler feet to level the unit.
Loosen nut with supplied wrench
and tighten to the locked position.
LIMITED WARRANTY
Salamander is proud to stand behind our products with industry-leading
warranties. Should you ever encounter any problem with your Salamander
product, let us know. We are here to make it right. 1.800.535.5659.
Full warranty including limitations and warranty claim information may be
found at www.salamanderdesigns.com/commercial/warranty
(STR170/MS50/FH1)
501-760-MS v1.23
page 1 of 8
Advertisement
Related Manuals for Salamander Designs Strut 170
Summary of Contents for Salamander Designs Strut 170
- Page 1 We are here to make it right. 1.800.535.5659. Full warranty including limitations and warranty claim information may be found at www.salamanderdesigns.com/commercial/warranty Strut 170 Wall Stand Designed for Microsoft Surface 2S 50” 501-760-MS v1.23 page 1 of 8...
- Page 2 811 BLUE HILLS AVE. - ALL THREADS TO BE CLASS 2 BLOOMFIELD, CT 06002 - COUNTERSINK ALL TAPPED HOLES Strut 170 Wall Stand Designed for Microsoft Surface 2S 50” 501-760-MS v1.23 page 2 of 8 /T/ 860.313.0525 /F/ 860.313.0526 - DEBURR HOLES AND BREAK SHARP EDGES...
- Page 3 Position display mount panel to the desired height by aligning the two top screws to the appropriate holes in the post and tighten all four screws. Strut 170 Wall Stand Designed for Microsoft Surface 2S 50” 501-760-MS v1.23 page 3 of 8...
- Page 4 Lift panels up and off, leaving the lift off panel screws. Remove the panel lock thumb screws on the lift-off panels from the backside of unit. Strut 170 Wall Stand Designed for Microsoft Surface 2S 50” 501-760-MS v1.23 page 4 of 8...
- Page 5 Reinstall Lift-Off Panels Depending on lift-off panel positions, screws may need to be repositioned. See diagram to locate appropriate position. Strut 170 Wall Stand Designed for Microsoft Surface 2S 50” 501-760-MS v1.23 page 5 of 8...
- Page 6 If using 2 peripherals, with one above and below, use a combination of 1 and 2 post mounts as shown. These can be either 1 post over 2 , or 2 posts over 1. Tech Shelf Tech Bracket page 6 of 8 Strut 170 Wall Stand Designed for Microsoft Surface 2S 50” 501-760-MS v1.23...
- Page 7 Move Strut 170 to wall and attach to side,snapping of straps level with bracket. Insert bolt through Bracket flange of cap. and tighten until snug against wall. Strut 170 Wall Stand Designed for Microsoft Surface 2S 50” 501-760-MS v1.23 page 7 of 8...
- Page 8 Attach display mount brackets in locations shown using the 4 M6x14 screws Install Display Insert the four shoulder washers on the brackets through the keyhole openings and rest washers at the bottom of the openings. Strut 170 Wall Stand Designed for Microsoft Surface 2S 50” 501-760-MS v1.23 page 8 of 8...