Toyota 4-Runner-U 2006 Manual page 181

WWW.MANUALS.WS
The slip indicator light and downhill assist
control system indicator light come on for
a few seconds when the ignition key is
turned to "ON". If any of the indicator
lights does not come on when the ignition
is turned on, contact your Toyota dealer.
The brake actuator temperature increases
during continuous operation of the hill-
start assist control system, the active
traction control system and the vehicle
stability control system. If the brake ac-
tuator temperature becomes too high while
any of the systems is operating, a buzzer
will start to sound intermittently to indicate
that the downhill assist control system can
no longer operate. In this case, stop your
vehicle immediately at a safe place.
If the system continues to operate, the
buzzer sound changes from intermittent to
continuous. (The continuous
sounds for about 3 seconds.)
WWW.MANUALS.WS
'06 4Runner_U (L/O 0508)
At this time, the slip indicator light will
come on, the downhill assist control sys-
tem indicator light flash and the downhill
assist control system stops operating tem-
porarily in order to protect the brake ac-
tuator. (Although the downhill assist con-
trol system does not operate, it is no
problem to continue your driving.) The
system will be automatically restored after
a short time and the slip indicator light
and the downhill assist control system in-
dicator light go out.
buzzer
If there is any abnormality in the sys-
tem, the "VSC TRAC" warning light will
come on. When the "DAC" switch is
pushed, the downhill assist control sys-
tem indicator light also flash.
If the "VSC TRAC" warning light comes
on, there may be an abnormality in any
of the following systems in addition to the
downhill assist control system.
"
Hill- start assist control system
"
Active traction control system
"
Vehicle stability control system
181