Toyota 4-Runner-U 2006 Manual page 311

WWW.MANUALS.WS
6. Test the operation of the HomeLink
pressing the newly programmed button.
Check to see if the gate/device oper-
ates correctly.
7. Repeat steps 1 through 6 for each re-
R
maining HomeLink button to program
another device.
Programming other devices
To program other devices such as home
security systems, home door locks or
lighting, contact your authorized Toyota
dealer for assistance.
Reprogramming a button
R
Individual HomeLink buttons cannot be
erased, however, to reprogram a single
button, follow the procedure "Programming
R
the HomeLink ".
R
(b) Operating the HomeLink
R
To operate the HomeLink , press the
R
appropriate HomeLink button to activate
the programmed device. The HomeLink
indicator light should come on.
R
HomeLink continues to send the signal
for up to 20 seconds as long as the
button is pressed.
WWW.MANUALS.WS
'06 4Runner_U (L/O 0508)
R
by
(c) Erasing the entire
memory (all three programs)
To erase all previously programmed codes
at one time, press and hold down the 2
outside buttons for 20 seconds until the
indicator light flashes.
If you sell your vehicle, be sure to erase
the programs stored in the HomeLink
R
memory.
The
For additional programming assistance
with your HomeLink
Transceiver call the:
A
The Toyota Customer
Center at 1- 800- 331- 4331 (U.S.A.)
A
Toyota Canada
Centre at 1- 888- 869- 6828 (Canada)
R
Refer to HomeLink
WWW.HOMELINK.COM
R
HomeLink
R
R
Universal
Experience
Customer Interaction
on the internet at:
311