Husqvarna HG 125 VS Original Instructions Manual page 14

Abrasive Type 41/1A and 27
Cutting Wheel Assembly
operations. Other guards or attachments may
not protect operator in the event of a wheel
burst.
tool operations. Do not discard guard when
not in use. Always reinstall wheel guard when
converting back to grinding operations.
To install cutting wheel (Fig. 8):
1.Unplug tool from power source.
2.Install and adjust Type 41/1A cutting
guard to the proper position for cutting as
shown in figure 5.
3.Place the backing flange on the spindle.
Turn flange until it locks with the base of
the spindle.
4.Place the cutting wheel onto the spindle
and align the arbor hole of the cutting
wheel with the shoulder of the backing
flange.
5.Thread the lock nut onto the spindle with
the lock nut relief facing the accessory.
6.Tighten lock nut with supplied lock nut
wrench while holding spindle lock.
TO REMOVE: Reverse procedure.
Assembly Instructions
Always use Type 41/1A
cutting guard for cutting
A type 27 wheel guard
may not be used for all
FIG. 8
TYPE 41/1A
CUTTING
WHEEL
TYPE 27A
CUTTING
WHEEL
-14-
TYPE 41/1A
WHEEL GUARD
BACKING
FLANGE
LOCK NUT
BACKING
FLANGE
LOCK NUT
SPINDLE
TYPE 27A
CUTTING
WHEEL
SPINDLE