Husqvarna HG 125 VS Original Instructions Manual page 11

Assembly Instructions
FIG. 2
Lock Nut & Backing Flange
Your tool is equipped with a threaded
spindle for mounting non-threaded hub
accessories. Always use the supplied
backing flange with a lock nut. Inner flange
is keyed to output shaft (Fig. 2). Always
ensure that arbor diameter matches
accessory diameter. Accessories that run
eccentrically may burst.
SPINDLE
KEYED
Installing Side Handle
TO SHAFT
BACKING
FLANGE
The side handle is used to control and
balance the tool. Securely thread handle
into either side of gear housing, depending
LOCK NUT
on personal preference, comfort, operation
being performed. The handle should always
(GUARD NOT SHOWN FOR CLARITY)
be installed onto the guard protected side
of the tool (Fig. 3). Use the side handle for
safe control and ease of operation.
FIG. 3
SIDE
HANDLE
-11-