Table of Contents
Advertisement
Available languages
Available languages
Wire Brush (Wheels
and Cups)
Wire brushes are intended to "clean"
structural steel, castings, sheet metal,
stone, and concrete. They are used to
remove rust, scale, and paint.
1. Allow the tool to reach full speed before
touching the tool to the work surface.
2. Apply minimum pressure to the work
surface, allowing the tool to operate at
high speed.
3. Continuously move the tool at a moderate
speed to avoid creating gouges in the
work surface.
4. Remove the tool from work surface
before turning tool off. Allow the tool to
stop rotating before laying it down.
Tip: The tips of the brush do the work.
Operate wire brushes with the lightest
pressure so only the tips of the wire come
in contact with the work piece. If heavier
pressures are used, the wires will be
overstressed, resulting in a wiping action
and a shortened brush life due to wire
fatigue. Applying the side or edge of the
brush to the work piece will result in wire
breakage and shortened brush life. (Fig. 22)
Service
unauthorized per so n nel may result in
misplacing
of
components which could cause serious
hazard. We recommend that all tool service
be performed by a Husqvarna Factory
Service Center or Autho rized Husqvarna
Service Station.
Operating Instructions
To avoid accidents always dis connect the tool from the power supply
before cleaning or performing any main tenance.
Preventive maintenance
performed
internal
wires
FIG. 22
CORRECT:
Wire tips doing
the work.
INCORRECT:
Excessive
pressure can
cause wire
breakage.
CORRECT:
Wire tips doing
the work.
INCORRECT:
Excessive
pressure can
cause wire
breakage.
Maintenance
GFCI and personal protection devices like
electrician's rubber gloves and footwear will
further enhance your personal safety.
by
Tool Lubrication
and
Your Husqvarna tool has been properly
lubricated and is ready to use. It is
recommended that tools with gears be
regreased with a special gear lubricant at
every brush change.
-23-
WIRE WHEEL BRUSH
WIRE CUP BRUSH
Advertisement
Table of Contents
